Panasonic AV-HS450N - Manual (Page 27)

27
2. Functions in each area
2-1-6. Positioner area
 Positioner [X/Y]
These are used when performing the settings below.
 PinP1, PinP2 position settings
 Wipe start position setting (WIPE #5, WIPE #11, SQ #5)
 Camera control
 Flying key position setting
 Chroma key marker position setting POSITIONER
Z


In each case, the settings take effect only when the following menu items have been selected.
The center values of the positioner are set during the time it takes for the unit to start up after its power is
turned on. Do not operate the positioner until after the switcher has started up.
Note
 Rotary encoder [Z]
This is used to set the PinP size, flying key size or to select the chroma key area.
In each case, the settings take effect only when the following menu items have been selected.
Positioner Rotary encoder
Valid menu
X/Y Z Switch
PinP1, PinP2 Position adjustments Size adjustments
(size increased by rotating
the encoder clockwise
and reduced by rotating it
counterclockwise) Hold switch down to
restore initial values
(X/Y, Z). All PinP1 and PinP2
menus (except for
PinP1, PinP2/Rotation)
Rotation angle
adjustments
(X-direction and
Y-direction rotation) Rotation angle
adjustments
(Z-direction rotation) Hold switch down to
restore initial values
(X/Y, Z). PinP1, PinP2/
Rotation
WIPE (BKGD) Start position
adjustments — Hold switch down to
restore initial values
(X/Y). BKGD/WIPEPos
BKGD/SQPos
WIPE (KEY) Start position
adjustments — Hold switch down to
restore initial values
(X/Y). KEY/WIPEPos
KEY/SQPos
Chroma key Selection position
adjustments Selected area size
adjustments
(size increased by rotating
the encoder clockwise
and reduced by rotating it
counterclockwise) Execute sampling CHR KEY/Sample1
CHR KEY/Sample2
Flying key Position adjustments Size adjustments
(size increased by rotating
the encoder clockwise
and reduced by rotating it
counterclockwise) Hold switch down to
restore initial values
(X/Y, Z). KEY/FlyKEY
Camera control X: Pan control or focus
control
Y: Tilt control or zoom
control
— Switching between
pan/tilt control and
zoom/focus control All menus other than
those listed above