Ricoh Facsimile - Manual (Page 142)

Simplifying the Operation
132
7
Using a Program
Note
❒ Using the program causes the pre-
vious settings to be cleared.
❒ If you have no programmed desti-
nations or scan settings as pro-
grams, select the program number,
and then enter the fax number of
the destination and select the scan
settings you require.
AAAA
Make sure that the machine is in
facsimile mode and the standby
display is shown.
Note
❒ If the standby display is not
shown, press the {{{{Facsimile}}}}
key.
BBBB
Place the original.
CCCC
Press the
{{{{Program}}}} key.
DDDD
Confirm that [Recall] is selected,
and press the registered program
No.
The standby display appears.
Then, the programmed fax num-
ber is shown. Transmission Mode
is selected.
EEEE
Press the
{{{{Start}}}} key.
The fax number and specified time
are shown on the display, and the
machine starts to scan the original.
Transmission starts at the specified
time.
ZLFS310N
JupterC2_Fax_EN-F_FM.book Page 132 Monday, November 29, 2004 3:48 PM