Ricoh Facsimile - Manual (Page 174)

Administrator Setting
164
9
FFFF
Specify an End Receiver using the
destination list, and then press
[OK]
.
The receiver name is shown to the
right of [Receiver].
Note
❒ Press the button on the right of
the display to switch the desti-
nation between fax number, e-
mail address, IP-Fax destina-
tion, and folder.
❒ Set a folder destination in System
Initial Setting/Administrator
Setting/Register/Change/De-
lete Address Book. “Registering
Folders”, General Settings Guide.
❒ If you have specified a folder for
forwarding, you can specify the
file format used for forwarding.
See p.166 “User Parameters”
(switch 21, bit 3).
❒ If you make a mistake, press
[Clear] or the
{{{{Clear/Stop}}}} key be-
fore pressing [OK], and then try
again.
GGGG
Press [OK].
HHHH
Press the
{{{{User Tools/Counter}}}} key.
The standby display appears.
Quitting the forwarding function
AAAA
Press the
{{{{User Tools/Counter}}}} key.
BBBB
Press [Facsimile Features].
CCCC
Press [Administrator Tools].
DDDD
Press [Forwarding].
EEEE
Press [Off], and then press [OK].
FFFF
Press the
{{{{User Tools/Counter}}}} key.
The standby display appears.
Forwarding Mark
You can print a Forwarding Mark on
the receiver's messages that have
been forwarded.
The receiver can distinguish between
forwarded messages and usual recep-
tions.
Note
❒ You can specify whether or not to
print a Forwarding Mark in the
User Parameters. See p.166 “User
Parameters” (switch 02, bit 0).
JupterC2_Fax_EN-F_FM.book Page 164 Monday, November 29, 2004 3:48 PM