Ricoh Facsimile User Manual
Page 192
Administrator Setting
182
9
EEEE
Check that [Program / Change] is se-
lected.
FFFF
Select a box to program.
When programming a new box,
press [* Not Programed].
Note
❒ To change a box already pro-
grammed, press it and proceed
to step
I
.
GGGG
Press [Personal Box].
HHHH
Enter a box name, and then press
[OK]
.
Reference
“Entering Text”, General Set-
tings Guide
IIII
Enter a SUB Code.
Note
❒ To change the SUB Code, press
[Clear]
or the
{{{{Clear/Stop}}}} key,
and then try again. To change a
Box name, press [Box Name], and
then repeat the procedure from
step
H
.
JJJJ
Specify the settings you require.
If you do not want to program a
password or receiver, proceed to
step
K
.
Programming a password
A Press [Password].
B Enter a password, and then
press [OK].
Note
❒ If you make a mistake, press
[Clear]
or the
{{{{Clear/Stop}}}} key
before pressing [OK], and
then try again.
C Re-enter the password, and
then press [OK].
Note
❒ If you make a mistake, press
[Clear]
or the
{{{{Clear/Stop}}}} key
before pressing [OK], and
then try again.
❒ To change the password after
pressing [OK], press [Change]
and repeat steps
B and C, or
press [Cancel] and repeat the
procedure from step
A.
D Press [OK].
JupterC2_Fax_EN-F_FM.book Page 182 Monday, November 29, 2004 3:48 PM