Quantum Data 802BT - Manual (Page 102)

92 Chapter 6 Working with Test Sequences
Viewing the test sequence list
You can view the list of test sequences stored in the generator using the command line
interface, the internal sequence editor or VGM.
Viewing the test sequence list using the command line
Use the following procedure to view the test sequence list using the command line
interface.
To view the sequence list using the command line interface:
1. Establish a terminal session with the generator.
2. Load the default test sequence directory (seq) or custom sequence directory using the
following command:
DIRL seq
3. List the contents of the sequence directory by entering the following command:
NAMQ? 1 4 // lists test sequences from the first through the fourth
Deleting a test sequence using the command line
Use the following procedure to delete a test sequence list using the command line
interface.
To delete a test sequence using the command line interface:
1. Establish a terminal session with the generator.
2. Load the default test sequence directory (seq) or custom sequence directory and begin
an editing session using the following commands:
DIRL seq
DIRB
3. Delete the sequence by entering the following command:
NAMK myseq
ALLU
4. End and save the sequence editing session using the following command:
DIRE
DIRS