Quantum Data 802BT - Manual (Page 19)

802BT/802R Video Test Generator User Guide 9
Video interfaces
This section describes the video interfaces available on the generator.
VGA interface
Use to output analog video for testing analog video displays. The following table describes
the VGA connector pinouts.
DVI-I interface
Use to output digital video for testing DVI-compliant video displays. Note that the DVI-I
connector also provides an analog output which can be used to test analog formats with a
VGA to DVI adapter when the generator is in analog friendly mode.
The DVI connector pinouts are shown in the following table.
Pi Signal Pin Signal Pin Signal
1 Analog Red Video 6 Analog Red Video Ground 11 No Connection
2 Analog Green Video 7 Analog Green Video Ground 12 DDC/EDID Serial Data
3 Analog Blue Video 8 Analog Blue Video Ground 13 Horizontal Sync
4 No Connection 9 DDC/EDID +5 Vdc Out 14 Vertical Sync
5 Digital Ground 10 Digital Ground 15 DDC/EDID Data Clock
Pin Signal Pin Signal Pin Signal Pin Signal
1 TMDS D2- 9 TMDS D1- 17 TMDS D0- C1 Analog Red
2 TMDS D2+ 10 TMDS D1+ 18 TMDS D0+ C2 Analog Green
3 D2/4 Shield 11 D1/3 Shield 19 D0/5 Shield C3 Analog Blue
4 TMDS D4- 12 TMDS D3- 20 TMDS D5- C4 Horizontal Sync
5 TMDS D4+ 13 TMDS D3+ 21 TMDS D5+ C5 Analog Ground
6 DDC Clock 14 +5 Vdc 22 Clock Shield
7 DDC Data 15 Ground 23 TMDS Clock+
8 No Connection 16 Hot Plug Detect 24 TMDS Clock-