Wolf DCX-1000I - Manual (Page 113)

Wolf Cinema Owner's Manual B-13
blb blue blacklevel
Set or request the blue Blacklevel (0-511) for a specific source setup.
blD blue Drive
Set or request the blue Drive (0-511) for a specific source setup.
bOG blue Odd Gain
Set or request the blue Odd Gain (0-255) for a specific source setup. You can set an Odd Gain
value for two separate analog input paths. The first input path is Input 1 (BNC connectors). The
second input path is one of: input 2 (DVi-a connector), or input 5 or input 6 (one of the analog
option cards).
To leave one of the input values unaffected, enter a value of 0 for the input. if only one value is
specified, then both input paths will have the same value.
examples:
(BOG 130 135) Sets the BnC analog path to 130, the DVi/option card path to 135. (BOG 0 120)
leaves the BnC path as it was, the DVi/option card path to 120. (BOG 125) Sets both paths to
125.
bOO blue Odd Offset
Set or request the blue Odd Offset (0-255) for a specific source setup. You can set an Odd Offset
value for two separate analog input paths. The first input path is Input 1 (BNC connectors). The
second input path is one of: input 2 (DVi-a connector), or input 5 or input 6 (one of the analog
option cards).
To leave one of the input values unaffected, enter a value of 0 for the input. if only one value is
specified, then both input paths will have the same value.
bRT brightness
Set the image brightness from 0-1000. The BrT value represents a percentage, e.g. 1000=100.0
% or 0505=50.5%.
bRU White Field Uniformity
Use BrU to adjust light output in the 8 zones around the central zone in the image, and/or to
turn BRU on/off. To find out if BRU is on, send a request with no parameters. The reply will be
“off” (0) or “on” (1).
examples:
(BrU 2 0 65) Set right red zone to 65.
(BrU 5 G 24) Set top left green zone to 24.
(bru? 0 B) What is the overall brightness of blue?
(bru! 0 B 039) The overall brightness of blue is 39.
(BrU 1) enable White Field Uniformity feature (if feature is available).
(bru?) What is the status of the Uniformity enable feature/checkbox?
(bru! 1) White Field Uniformity is enabled.
3.16 blb
blue blacklevel
3.17 blD
blue Drive
3.18 bOG
blue Odd Gain
3.19 bOO
blue Odd Offset
3.20 bRT
brightness
3.21 bRU
White Field Uniformity
Appendix B ► Serial Communications