Wolf DCX-1000I - Manual (Page 32)

Wolf Cinema Owner's Manual 3-8
Function Key
IF WITHIn a MenU: Using the Func for special tasks within the menu system is noted with the
appropriate topic elsewhere in Section 3. For example, press Func in the Channel Setup menu
to enable deletion or copying of a channel.
SETUP FUNCTIONS: Press Func followed by a 2-digit number
to enable a specific color or colors in the display (see right). For
example,
Func 6 4 will display only red and green data,
Func 6 7 will display all color data. eliminating one or
more colors can help with certain diagnostics and setups.
nOTe: Color enabling can also be implemented from numerous
locations within the menu system.
Projector
Press Proj
to access a specific projector within a group of projectors or to confirm if the local
projector is listening. The number in the “enter number” window indicates which projector is
currently listening to commands, and will match the projector number that has been defined in
the Menu Preferences menu.
The “Projector” checkbox (read-only) shows whether or not the projector physically connected
to a keypad is listening to commands from that keypad. a checkmark means that connected
projector is listening; if there is no checkmark, you are communicating with a different projector.
To control a specific projector with the keypad, press
Proj and then enter the three-digit number
assigned to the projector you want to use. if you switch to a projector other than the one you are
currently using, the checkmark will disappear.
To broadcast to multiple projectors, press Proj and then Proj again without entering a projector
number. Keypad commands will then affect all projectors present. note that there is no method
of controlling a group of projectors within the same wired configuration using the wired keypad
exclusively, since there is only one wired protocol available.
nOTes: 1) The "Broadcast Keys" option in the Communications menu must be selected for
only one (any) projector in a serial network. The keypad in use must be OFF (disabled) for the
remaining projectors. 2) See 3.6, Adjusting System Parameters and Advanced Controls.
Enter
Press

to select a highlighted item, to toggle a checkbox, or to accept a parameter adjustment
and return to the previous menu or image.
Exit
Press exit to return to the previous level, such as the previous menu.
nOTe: exit does not save changes within text editing boxes (including number editing of a
slide bar value) or within pull-down lists. It acts as a “cancel” in these cases.
Section 3 ► Operation
Func
Proj

exit