Wolf DCX-1000I - Manual (Page 92)

Wolf Cinema Owner's Manual 4-6
Section 4 ► Maintenance
nOTe: The lamp mode you choose to run the projector in may have an impact on the number
of hours expected for the lamp.
Tools required: #2 Phillips screwdriver
Warnings
A qualified service technician must perform lamp replacement.
Cool the lamp completely and handle by the housing only.
Install the correct wattage lamp supplied by Wolf Cinema (see above) and read the
lamp Replacement procedure in its entirety before proceeding.
Do not touch the glass surface of the lamp. Fingerprints left on the surface can
lead to an intense accumulation of heat called a “hotspot”, which could potentially
result in the lamp shattering. It is recommended you wear clean, lint-free gloves
and a face shield when working with the lamp.
1. TURn THe laMP OFF
Press (power) to turn the lamp off. allow the cooling fans to stop automatically (within
approximately five minutes) before proceeding with Step 2. This wait period is also required
to allow the lamp to sufficiently cool before handling.
2. UnPlUG THe PROJeCTOR
When the cooling fans have stopped, turn the projector’s main switch off, and unplug.
WaRnInG
always power down and unplug the projector prior to servicing.
allow the lamps to cool before handling.
3. ReMOVe THe laMP DOOR
WaRnInG
Protective gear required. Wear a face shield.
Using a #2 Phillips screwdriver, remove the two (2) screws securing the lamp door, which is
located at the rear of the projector below the input panel. See Figure 4.2.
Figure 4.2. Open Lamp Door
Iso - Rear Left View
Iso - Front Right View
Rear View
Top View
Side - Left View Side - Right View
Iso - Rear Right View
Lamp Door - 2 Screws