Wolf DCX-1000I User Manual
Page 149
Advertising
Wolf Cinema Owner's Manual
D-2
Real Time Event
Use the serial command rTe to specify an action that is initiated at a particular time or based
on an external stimulus.
For General Purpose IO “G”
Parameter
name
Value
P1
rTe type
G (real Time i/O event)
P2
i/O bit
1-7
P3
Pin state
(1 Character)
(String)
H = High
l = low
“lHXXXHl” Combine multiple inputs and trigger occurs
when all conditions are met
P4
Commands
any valid serial protocol command for the device
example 2. Projector powers up when a switch on the external device is turned on.
(GIO C2 I)
Set pin #2 configuration as input
(RTE G 2 H “(PWR 1)”)
Power on when pin #2 set to high
(RTE G 2 L “(PWR 0)”)
Power off when pin #2 set to low
Appendix D ► System Integration
Advertising
This manual is related to the following products: