Wolf DCX-1000I - Manual (Page 30)

Wolf Cinema Owner's Manual 3-6
Section 3 ► Operation
Channel
Press Channel
to select a specific source setup (channel) defined and stored in projector memory.
Once you enter a two-digit channel number (or, if there is a list displayed, highlight it and press
 ), the display will automatically change and update according to the numerous setup
parameters defined for that channel. Note that a new channel is automatically created if you
adjust an image from a new source.
nOTe: Channel ( Channel ) key behavior during a presentation depends on whether or not the
Display Channel List option is enabled in the Menu Preferences menu. You can choose to
use a scrollable list of channels when you press
Channel , or you may prefer to enter the desired
channel number “blind”, i.e., without on-screen feedback. See Menu Preferences later in this
section.
Input 1
Press input 1 to display from the data or video input source connected to BnCs labeled InPUT
1.
Input 2
Press input 2 to display from the DVi source connected to InPUT 2.
Input 3
Press input 3 to display from the composite video source connected to InPUT 3.
Input 4
Press input 4 to display from the S-Video source connected to InPUT 4.
Input 5
Press input 5 to display from the InPUT 5 interface module installed in the Option 1 slot.
nOTe: If you have the optional Dual SD/HD-SDI Module installed and there are two inputs
connected here, the second input (B) is considered INPUT 7. If you are using the built-in keypad
or the remote keypad, press INPUT 5 to access INPUT 7 as follows:
While displaying from
•
INPUT 5, press input 5 again. This switches to INPUT 7.
While displaying from any input other than the Dual SD/HD-SDI Module, press
•
input 5 . This
switches to either INPUT 5 or INPUT 7, depending on which of the Dual SD/HD-SDI Module
inputs (A or B) was last used. Press
input 5 again to display from the other Dual SD/HD-SDI
Module input.
Input 6
Press input 6 to display from the INPUT 6 interface module installed in the Option 2 slot.
nOTe: If you have the optional Dual SD/HD-SDI Module installed and there are two inputs
connected here, the second input (B) is considered INPUT 8. If you are using the built-in keypad
or the remote keypad, press INPUT 6 to access INPUT 8 as follows:
While displaying from
•
INPUT 6, press input 5 again. This switches to INPUT 8.
While displaying from any input other than the Dual SD/HD-SDI Module, press •
input 5 , which
switches to either INPUT 5 or INPUT 8, depending on which of the Dual SD/HD-SDI Module
inputs (A or B) was last used. Press
input 5 again to display from the other Dual SD/HD-SDI
Module input.
Channel
input 1
input 2
input 3
input 4
input 5
input 6