Wolf DCX-1000I - Manual (Page 93)

Wolf Cinema Owner's Manual 4-7
Section 4 ► Maintenance
4. Release THe laMP lOCK
Pull out and turn the lamp lock lever, which is located to the left of the lamp module, and turn
it ¼ turn counter clockwise to the “unlock” position. See Figure 4.3.
5. ReMOVe THe laMP MODUle
Firmly grasp the lamp by its housing only and pull it straight out (lamp slides along guides)
until it is free. See Figure 4.4. Discard the lamp using safe disposal/recycling practices.
6. InseRT THe neW laMP MODUle
align the new lamp with the top and bottom guides on the left side of the lamp compartment
(see Figure 4.5). Slide the lamp all the way in – a slightly harder push may be required right
at the end to ensure it’s fully seated into the terminal block.
nOTe: The lamp module must make full contact with the terminal block. The projector will
not power up again if the lamp is not fully connected to the terminal block.
WaRnInG
Improper installation could cause a serious meltdown inside the projector.
Figure 4.4. Remove the Lamp Module
Iso - Rear Left View
Iso - Front Right View
Rear View
Top View
Side - Left View Side - Right View
Iso - Rear Right View
Figure 4.5. Insert New Lamp Module
Iso - Rear Left View
Iso - Front Right View
Rear View
Top View
Side - Left View Side - Right View
Iso - Rear Right View
Figure 4.3. Release the Lamp Lock