Wolf DCX-1000I User Manual
Page 119
Wolf Cinema Owner's Manual
B-19
Parameter Value
Description
P1
1-16
(P1: 1-9 = blend edge/zone brightness)
(P1: 10-13 = edge zone width)
(P1: 14-16 = color components of overall black level)
1 = Center
2 = Top
3 = Bottom
4 = left
5 = right
6 = Top left
7 = Top right
8 = Bottom left
9 = Bottom right
10 = left Width
11 = right Width
12 = Top Width
13 = Bottom Width
14 = Black red level
15 = Black Green level
16 = Black Blue level
P2
When P1 = 1-9, P2 = 0-247
When P1 = 10-13, P2 = 0-255
When P1 = 14-16, P2 = 0-255
Brightness (0-247)
Zone Width (0-255)
Color level (0-255)
examples:
(BeB 2 15)
Set Brightness of top edge to 15
(BeB?)
request state of Black edge Blending
(BeB! 1)
Black edge Blending is enabled
ebe edge blending black levels select
This command enables (1) or disables (0) the Black edge Blending feature. This feature can only
be enabled when edge Blending has been enabled (eBS).
ebl edge blending
Use eBl to blend together the overlapping edges of adjacent images, and/or to turn eBl on/off.
To find out if EBL is on, send a request with no parameters. The reply will be “off” (0) or “on” (1).
note that on-screen values do not match values through aSCii messaging.
Parameter
Description
P1 = Which blend edge? or
(if Wolf WarP and no other
parameters)
P1 = Type of edge blending to
use.
0 = left
1 = right
2 = Top
3 = Bottom
Or, if Wolf WarP and no P2 or P3 parameters, P1=
0 = Disable
1 = enable normal Christie edge Blending
2 – 4 = User-defined custom blend (requires s/w v1.1 or
higher)
P2 = Which blend characteristic? 0 = Width of blend 1 = Shape of blend 2 = midpoint of
blend
P3 = Setting
left/right Width = 0, 5-80, Top/Bottom Width 5-60, Shape
2-30, midpoint 2-30
3.42 ebe
edge blending black
levels select
3.43 ebl
edge blending
Appendix B ► Serial Communications