Wolf DCX-1000I - Manual (Page 136)

Wolf Cinema Owner's Manual B-36
3.111 PHs
PIP Horizontal size
PHs PIP Horizontal size
NOTE: Not available in v1.0.
Use PHS to set what percentage (0-100) of the screen width to use for the width of the picture-
in-picture window. Height of the window will then be determined by the aspect ratio of the input
image.
PIP Picture-In-Picture
Use PiP to turn picture-in-picture on (1) or off (0). NOTE: Not available in software v1.0.
PJH Projector Hours of Use
Use PJH to determine the number of hours (0-16,777,215) the projector has been operated,
including cool-down modes.
PlK Parameter lockout
Use PlK to specify which menu options are to be locked from the user (note: a lockout can still
be accessed via aSCii command). in a PlK message, P1 represents the corresponding function
code (e.g., CnT, CTm, etc.) you wish to lock or unlock. Where several related options—such as
blanking controls—share a single lockout, locking or unlocking any one of the options toggles
the full lockout status.
To lock/unlock all options, omit any P1 function code from your PlK set message.
examples:
(PlK “COn” 1) lock the “Contrast” control
(PlK 1) lock all possible options
(PlK “BrT” 0) Unlock the “Brightness” control
PnD Plug & Display Modes
Use PnD to specify the display mode requested of the video source. note: The source computer
may need to be rebooted before this setting will take effect.
0 = Default Timing (native resolution @ 60Hz)
1 = 1024 x 768 x 116Hz
2 = 720p (1280 x 720 x 60Hz)
3 = 1080p50/1080i50
4 = 1280 x 1024 x 110Hz
5 = 1400 x 1050 x 60Hz
6 = 1400 x 1050 x 102Hz
7 = DC2k (2048 x 1080 x 60Hz)
8 = 1080p60/1080i60
9 = 1080p24/1080p30Hz
3.112 PIP
Picture-in-Picture
3.113 PJH
Projector Hours of Use
3.114 PlK
Parameter lockout
3.115 PnD
Plug & Display Modes
Appendix B ► Serial Communications