Wolf DCX-1000I - Manual (Page 19)

Wolf Cinema Owner's Manual 2-13
Figure 2.7 Connecting RGB and Sync
nOTes: 1) If for some reason the projector fails to recognize a signal as an RGB signal, specify
this Color Space option within the Picture Adjustments menu. See 3.5 Adjusting the Image.
2) To connect YPbPr signals–such as from DVDs or analog HDTV sources–to INPUT 1, use the
red, green and blue BNCs as described in YPbPr Signals (below).
Connect a yPbPr signal (component video) to InPUT 1 or InPUT 2 as shown in Figure 2.8.
nOTes: 1) If, for some reason, the projector fails to recognize a YPbPr signal, specify this Color
Space option within the Picture Adjustments menu. See 3.5, Adjusting the Image. 2) Do not
connect digital component signals (known as YCbCr) to InPUT 1. Install an appropriate optional
module in INPUT 5 or INPUT 6 for this.
YPbPr signals >
(COMPONENT VIDEO)
Figure 2.8 Connecting YPbPr sources
Video
Source
From
Digital
Signals
from YPbPr
Source
Section 2 ► Installation and Setup