Wolf DCX-1000I - Manual (Page 7)

Wolf Cinema Owner's Manual 2-1
2.1 Quick setup
seCTIOn 2
The instructions provided here are for those that are familiar with the projector and wish to
quickly set it up and use it temporarily. refer to the remaining subsections of this manual for a
more complete setup.
Install the Projection Lens
The projection lens is shipped separately from the projector and must be installed prior to setting
up the projector. install the projection lens as described in 4.5 Replacing the Projection Lens.
Remove the lens plug from the lens opening in the projector before installing the lens.
Remove the lens when shipping the projector and reuse the lens plug to prevent dust
and debris from entering and settling on critical optical components.
Position the Projector
Place the projector on a sturdy, level surface and position it so that it is perpendicular to the
screen at a suitable distance. in general, the further back the projector is positioned from the
screen, the larger the image will be.
if required, you can level the projector by adjusting its three feet. With the projector positioned
perpendicular to the screen the image will appear rectangular instead of keystoned.
For more detailed instructions on positioning the projector refer to Projector Position and
Mounting later in this section.
Connect a Source
located at the back of the projector is the input panel where all source connections are made.
Each input is clearly labeled for easy identification.
Using the appropriate cable(s), connect your source. Connect rGB and yPbPr sources to InPUT
1 located in the upper right corner of the input panel. Use the DVi-i connector at InPUT 2 to
connect analog or digital display signals. Connect composite video to InPUT 3 and S-Video to
InPUT 4.
nOTe: One of the available optional input modules can be installed at InPUT 5 or InPUT 6 for
additional connections.
refer to 2.3 Connecting Sources
for more details on connecting a specific source.
Step 1 >
Step 2 >
Step 3 >
InsTallaTIOn & seTUP