Wolf DCX-1000I - Manual (Page 135)

Wolf Cinema Owner's Manual B-35
OTF Output Format
Change output format for Cine-iPm 2K.
0 = Single link on DVi-1 or DVi-2
1 = Twin link
NOTE: DVI-1 has lower 8 bits; DVI-2 has higher 2 bits).
PaP PIP aspect Ratio Preset
Use PaP to select the preferred aspect ratio for your Picture-in-Picture window.
0 = Default
1 = anamorphic
2 = Custom (response only – The vertical stretch does not correspond to one of the
settings.)
PbC PIP border Color
Use PBC to select the color for the Picture-in-Picture window border.
0=Black
1=Darkred
2=DarkGreen
3=DarkBlue
4=DarkCyan
5=Darkmagenta
6=Darkyellow
7=DarkGrey
8=lightGrey
9=red
10=Green
11=Blue
12=Cyan
13=magenta
14=yellow
15=White
See also PBW.
PbW PIP border Width
Use PBW to specify the width (0-10) of the border of the Picture-in-Picture window.
See also PBC.
PDT Peak Detector
enable (1) or disable (0) the peak detector test mode as an aid in setting up input levels.
PHP PIP Horizontal Position
NOTE: Not available in v1.0.
Use PHP to set the horizontal position (0-100) of the picture-in-picture window. range is a
percentage of the screen size.
3.105 OTF
Output Format
3.106 PaP
PIP aspect Ratio Preset
3.107 PbC
PIP border Color
3.108 PbW
PIP border Width
3.109 PDT
Peak Detector
3.110 PHP
PIP Horizontal Position
Appendix B ► Serial Communications