Wolf DCX-1000I - Manual (Page 15)

Wolf Cinema Owner's Manual 2-9
The horizontal position of the image can be offset – that is moved to the left or right of lens
center, by adjusting the fully motorized lens mount through software. The amount of horizontal
offset available depends on the lens installed and if the image has already been vertically offset.
Horizontal offset can also be expressed as the percent of half the image width – the number
of pixels of shift to one side of lens center. refer to Figure 2.3 for some illustrated examples of
horizontal offset.
See also Table 2.1 along with Figure 2.4 which shows the maximum horizontal offset of a lens
or alternatively, how much of your projected image will appear to one side of lens center if the
maximum horizontal offset is applied using that lens.
Figure 2.3 Horizontal Offset Examples
Section 2 ► Installation and Setup
Iso - Rear Left View Iso - Front Right View
Rear View
Top View
Side - Left View Side - Right View
Iso - Rear Left View Iso - Front Right View
Rear View
Top View
Side - Left View Side - Right View