GE Industrial Solutions Galaxy Verification - Manual (Page 20)

Galaxy Power System Verification Procedures
2 - 8 Galaxy SC Controller Performance Verification Procedures Issue 3 January 2008
Alarm Test, continued
Remote Alarm Test Using EasyView to perform the Alarm Test, hardware switches
SW202-5 on the BJB board and SW204-2 on the BJH board must first
be enabled, in addition to the software switches located at menu path.
EasyView: CONFIGURE → DC PLANT → HARDWARE AND
SOFTWARE CONFIGURED
Both the Alarm Test and Remote Alarm Test fields must be enabled.
Initiate the test remotely with the EasyView path:
CONTROL → ALARM TEST.
Follow the status of the test remotely with the EasyView path:
STATUS → ALARM TEST.