GE Industrial Solutions Galaxy Verification - Manual (Page 75)

Galaxy Power System Verification Procedures
Issue 3 January 2008 Replacement Procedures 4 - 7
Memory Backup Battery Replacement for Millennium
Controller, continued
Replace Memory
Backup Battery
Step Action
1 Remove the memory battery. Take care not to flex the
battery holder clip excessively.
2 Insert the memory battery into the BSJ (Intelligent
Controller) circuit pack X201 battery holder. Observe proper
polarity; the battery holder clip contacts the “+” side of the
memory battery. Take care not to flex the battery holder clip
excessively.
Restore System
Configuration
Step Action
1 Log in and begin an EasyView session using the previously
modified connection profile.
2 Open the File menu and click on Restore. Select the
configuration file you saved when you performed the
Backup operation. Click OK. EasyView displays the status
of the backup. Click OK when the Restore operation is
complete
3 Open the Configure menu and click on Configure
Passwords. Change the passwords from the default setting to
the appropriate password for your site.
4 Open the Configure menu and click on System → System
Time. Set the System time and date. Click OK.
5 If passwords are not at system defaults, open the Options
menu and click on Setup Sites. Select your connection
profile from the Site list. Click Modify. Change the
passwords to those chosen for the site. Click OK. Click
Close.
6 Open the Connect menu and select Disconnect to end the
EasyView session.