GE Industrial Solutions Galaxy Verification - Manual (Page 80)

Galaxy Power System Verification Procedures
4 - 12 Replacement Procedures Issue 3 January 2008
GPS2424 Replacement Procedures, continued
Replacing a 596B3
Rectifier Fan
Assembly
Stop! Review the “Installing or Replacing a Rectifier” procedure in this
section before proceeding.
Step Action
1 Remove the rectifier from the system. See the “Installing or
Replacing a Rectifier” procedure in this section.
2 WAIT five minutes for capacitors to discharge.
3 Loosen the white front cover by removing 14 screws (5 top,
5 bottom, 2 on each side). Before fully removing the cover,
disconnect the ribbon cable from the display circuit pack.
4 Remove the screws attaching the old fans to the chassis and
carefully unplug the fan connector. The fan connector is keyed
and can be loosened by inserting a screwdriver into the slotted
side of the connector and gently prying the fan-side connector
loose.
5 Replace the new fans.
6 Reconnect the ribbon cable removed in Step 3.
7 Attach the front cover.
8 Install the rectifier, following instructions in the “Installing or
Replacing a Rectifier” procedure in this section.