Anritsu Series MS278XB - Manual (Page 116)

Menu Archive Front Panel Menus
4-18 MS278XB OM
Marker Config Menu
The Marker Config menu lets you select the following:
Display Lines Menu
The Display Lines menu lets you display limit lines.
Table 4-11. Marker Config Menu
Marker -> Trace: To select the trace that receives the marker, press on the Marker On
Trace field and select the trace from the fly-out menu.
Marker Table: A marker table can be displayed at the bottom of the graticule. To toggle
the table on or off, press on the Off/On Marker Table button.
Marker Function: The Marker Function activates Noise Markers (refer to “Measuring
Phase Noise” on page 5-27 for information on phase noise measurements).
Table 4-12. Display Lines Menu
Horizontal Line: To set the level for a limit line, press in the Horizontal Line parameter
field and enter a value using the numeric keys. When a new value is entered, the
terminator fly-out will appear with the available units. The following unit terminators are
supported when the appropriate amplitude units are selected:
dBm, -dBm
dBmV, -dBmV
dBµV, -dBµV
W, mW, µW, nW, pW, fW, aW
V, mV, µV, nV, pV
Press on the desired units to terminate the entry, then toggle the limit line on by pressing
on the Off/On toggle button.