Anritsu Series MS278XB - Manual (Page 181)

Measurements Measurement Examples
MS278XB OM 5-25
Displaying Detectors
The following example shows an example of a 1 GHz carrier using the Average, RMS, Minimum, and
Maximum detectors:
1. Preset the analyzer using the Preset button.
2. Set the center frequency to 1 GHz and the span to 300 kHz.
3. On the Trace Config menu, set the Trace 1 detector to Average.
4. Select Trace 2 as the active trace and set it’s detector to RMS.
5. Select Trace 3 as the active trace and set it’s detector to Minimum.
6. Select Trace 4 as the active trace and set it’s detector to Maximum.
The display should look like the one in the figure below:
Figure 5-6. Displaying Detector Modes