Anritsu Series MS278XB - Manual (Page 126)

Menu Archive Front Panel Menus
4-28 MS278XB OM
Sweep Menu
The Sweep menu lets you lets you select between continuous or single sweep modes, and to start a single
sweep.
Table 4-17. Sweep Menu
Sweep Time: To set the sweep time, press in the Sweep Time parameter field and enter
the desired sweep time value. When a new value is entered, the terminator fly-out will
appear with the available units. Press on the desired units to terminate the entry.
To change between manual or auto sweep time, press on the Manual/Auto toggle button.
Sweep Mode: To toggle the sweep mode between continuous and single sweep, press
the Continuous/Single toggle button.
When in the Single Sweep mode, press the Sweep button to trigger a new sweep.
Sweep Type: To change the sweep type, press the Sweep Type button and select the
desired sweep mode from the following fly-out menu selections:
Swept: Selects a normal sweep.
FFT: Selects a Fast Fourier Transform sweep (maximum span limited to 1 MHz)
FFT WideBand: Selects a Wideband Fast Fourier Transform sweep with spans
up to 30 MHz (requires Option 22).