Anritsu Series MS278XB - Manual (Page 170)

Basic Measurement Setups Measurements
5-14 MS278XB OM
Setting Trace Modes
Signature can display up to five traces, each using different trace modes and detectors. Set up the various trace
modes and detectors as follows:
1. Press the Trace icon on the main menu bar, or press the Trace key on the instrument front panel, to
display the Trace Config menu below:
2. Press the Trace Select button and select the trace you wish to make active from the fly-out menu.
Note: By default, Trace 1 is set to the active trace in the Clear-Write state. When a new trace is selected as the
active trace, the Trace 1 mode is set to Off (Blank) by default and is not displayed until a new mode is
selected.