Anritsu Series MS278XB - Manual (Page 40)

Remote Interface Setup Preparation for Use
2-16 MS278XB OM
LAN Setup
The LAN can be set up via the RJ45 Ethernet port.
Network Connections
The MS278XB supports 10/100 BASE-T. You can connect the analyzer directly to your LAN via the RJ45
connector on the rear panel. Refer to Figure 2-14, below, for an illustration.
Network Interface Setup
TCP/IP connectivity requires setting up the parameters described at the beginning of this section. You
may need to contact your network administrator or refer to your network documentation for further
assistance. The following procedure is a general overview of how to set up a general LAN connection on
both the MS278XB and the remote machine. The actual menus and sequence may vary.
1. From the Start menu, select Control Panel.
Figure 2-15. Ethernet Connection
Figure 2-16. Start Menu