E-Mon E-PS-E-RTU-N - Manual (Page 102)

Chapter 5 Configuring the PowerSmart+ PQM Configuring Recorders
102 PowerSmart+ Power Quality Meter
4. Select the maximum number of records you want to be recorded
in the file.
5. Click OK, and then send your new setup to the meter, or save to
the device database.
To define the contents of the file:
1. Highlight the data log file row with the left mouse button, and
then click on the Setup Recorder button, or click on the Data
Recorder tab and select the corresponding log number.
Figure 5-20: Log Setup Dialog Box – Data Recorder Tab
2. Configure the list of parameters to be recorded in a log file. You
are not allowed to select more parameters than you defined
when configuring your file. Refer to Appendix D for a list of
available parameters.
3. For your convenience, Power Software follows your selection and
helps you configure a series of the neighboring parameters:
when you open the Group box for the next parameter, Power
Software highlights the same group as in your previous
selection; if you select this group again, Power Software
automatically updates the Parameter box with the following
parameter in the group.
4. Add the name for your data log file in the Name box. It will
appear in the data log reports.
5. Save your new setup to the device database, and send it to the
meter.
Billing/TOU Daily Profile Log File
Data log #16 is configurable to store TOU daily profile log records on a
daily basis.
The file is organized as a multi-section file that has a separate section of
the same structure for each billing energy and maximum demand register.
The number of sections is taken automatically from the Billing/TOU Registers
setup (see
Configuring Billing/Tariff Registers ). If the maximum demand
profiling is used, then the number of sections in the file will be twice the
number of the allocated billing registers.