E-Mon E-PS-E-RTU-N - Manual (Page 72)

Chapter 5 Configuring the PowerSmart+ PQM Configuring Communications
72 PowerSmart+ Power Quality Meter
The following table lists available GPRS options.
Table 5: GPRS Setup Options
Parameter Default Description
Access Point Name (APN) internetg The mobile network APN name
User name Username (if required)
Password Password (if required)
GPRS mode Server mode Server or Client mode of
operation
2. Configure your mobile network APN, username and password.
Consult your network operator regarding proper network settings.
Leave the username and password fields blank if network
authorization is not required.
3. Send your GPRS settings to the meter.
4. Select the GPRS interface in the COM2 port setup (see Setting Up
Serial Communication Ports ).
5. Configure your eXpertPower client (see Setting Up eXpertPower
Client ) or/and TCP Notification client (see Setting Up TCP
Notification Client ) for communicating with a remote server.
You can check the status of the GPRS communications from the front
panel via the
Status Display or via the Device Control dialog in Power
Software (see Viewing Communication Status and Statistics ).
Setting Up eXpertPower Client
The PowerSmart+ PQM has an embedded eXpertPower TM client that
provides communications with the eXpertPower TM server – the proprietary
Cloud services. Connections to the eXpertPower TM server are handled on
a periodic basis.
To set up communications with the eXpertPower TM server, select
Communication Setup from the Meter Setup menu, and then click on
the ExpertPower Client Setup tab.
Figure 5-4: eXpertPower Client Setup Tab