E-Mon E-PS-E-RTU-N - Manual (Page 108)

Chapter 6 Device Control and Upgrading Resetting Accumulators, Maximum Values and Files
108 PowerSmart+ Power Quality Meter
Chapter 6 Device Control and Upgrading
This section describes operations on the meter you can perform from the
front display or via Power Software. To access device control options from
Power Software, you should have your meter online.
6.1 Resetting Accumulators, Maximum Values and Files
Using the Front Display
Select the RESET entry from the Device Setup menu. See Viewing and
Changing Setup Options in Chapter 3 for information on configuring
parameters via the front display.
To reset the desired values:
1. Select the desired parameter to be cleared using the UP/DOWN
button then press the ENTER button.
2. Press the ENTER button for approximately 5 sec until the "Do"
notification is changed to "Done"
Table 20 shows the reset options available from the front display.
Table 20: Front Display Reset Options
Display Label Description
Volt/Ampere Demands Clears ampere and volt maximum demands
Power Demands Clears power maximum demands
All Demands Clears all maximum demands
Min/Max Clears Min/Max log
Energy Clears all total energies
Counters Clears all counters
Counter 1 Clears counter #1
Counter 2 Clears counter #2
Counter 3 Clears counter #3
Counter 4 Clears counter #4
Diagnostics Clears device diagnostics
Using Power Software
Ensure that the On-line button on the Power Software toolbar is checked,
and then select Reset from the Monitor menu.