E-Mon E-PS-A-RTU-N - Manual (Page 40)

Chapter 3 Display
O P E R A T I O N S U S I N G T H E M E N U S
40 PowerSmart+ Advanced Power Quality Meter
Using the Menus
Navigation Buttons Navigation Buttons Navigation Buttons Navigation Buttons
The PowerSmart+ Advanced PQM has a menu-driven setup. To enter the menus,
press and release the SELECT button.
The SELECT SELECT SELECT SELECT button selects (highlights) an active window in which you can select or
change a desired menu item. The button operates once it’s briefly pressed and
released.
The UP UP UP UP and DOWN DOWN DOWN DOWN arrow buttons scroll through menu items in the highlighted
window forwards and backwards, and allow changing a highlighted item when
entering numbers.
The ENTER ENTER ENTER ENTER button confirms the selection of a menu item or a number in the
highlighted window, thus allowing to enter a submenu or to store a changed item.
The ESC ESC ESC ESC button is “Escape” leaving the highlighted item unchanged or returning to
the upper level menu.
Selecting Menus Selecting Menus Selecting Menus Selecting Menus
To access the meter menus, press and release the SELECT button. The primary
meter menu is open as shown below. The menu has three entries:
• StA - Status Display entry (see ”Status Display” above)
• OPS – Main setup menu entry allowing to review setup options
• CHG – Main setup menu entry allowing to change setups
To enter the Status Display:
If the StA window is not highlighted, use the SELECT button to activate it.
Press the ENTER button to enter the Status Display
To review the meter setup options:
Press the SELECT button to activate the OPS window.
Press the ENTER button to enter the main menu.
To change the meter setup, or to clear the accumulated values:
Press the SELECT button to activate the CHG window.
Press the ENTER button to enter the main menu.
Entering the Password Entering the Password Entering the Password Entering the Password
The Setup Change menu can be secured by a four-digit user password. The meter
is primarily shipped with the password preset to 0 and password protection
disabled. You can change the password and enable password protection through
the Access Control menu (see
Meter Security ).
ENERGY
ENTER
THD/TDD
ESC
SELECT
StA
CHG
OPS
SELECT
StA
CHG
OPS
SELECT
ENERGY
ENTER