E-Mon E-PS-A-RTU-N - Manual (Page 81)

Chapter 4 Power
S O F T W A R E C O N F I G U R I N G R E C O R D E R S
PowerSmart+ Advanced Power Quality Meter 81
Configuring the Event Recorder Configuring the Event Recorder Configuring the Event Recorder Configuring the Event Recorder
To configure the Event log file:
Double click on the Event Log file partition with the left mouse button.
Select a partition type for your file.
Select the maximum number of records you want to be recorded in the file.
Click OK, then send your new setup to the meter or save to the device database.
By default, the Event recorder stores all events related to configuration changes,
reset, and device diagnostics. In addition, it records events related to setpoint
operations. Each setpoint should be individually enabled for recording to the Event
log.
To log setpoint operations, add the “Event log” action to the setpoint actions list.
When a setpoint event happens, the Event recorder logs all setpoint conditions that
caused the event and all setpoint actions performed in response to the event.
Logging actions themselves will not be recorded to the Event log.
Configuring the Data Recorder Configuring the Data Recorder Configuring the Data Recorder Configuring the Data Recorder
The Data recorder is programmable to record up to 16 data parameters per record
in each of 16 data log files. The list of parameters to be recorded to a data log is
configured individually for each file.
Conventional Data Log Files
To create a new data log file or re-configure an existing file:
Double click on the file partition with the left mouse button.
Select a partition type for your file.