System Sensor PDRP-2001 - Manual (Page 53)

PDRP-2001 Series Manual — P/N 53043:E1 2/28/2011 53
Master Programming Level Programming
Pressing the down arrow key displays additional zone types as indicated in the following table.
While viewing any Zone Type screen, select the type of zone being programmed by pressing the
corresponding keyboard number key. The display will return to Edit Input Zone Screen #2 and
indicate the selection next to the Type option.
Zone Type Action When Activated
Pull-Station Fire Alarm
Manual Release 1
1 Activation of a Manual Release Switch will override Predischarge Delay, resulting
in an immediate water release.
Fire Alarm
N/A
Normally Open Contact Fire
N/A
N/A
N/A
Waterflow Fire
Waterflow NS (nonsilenceable) Fire, nonsilenceable
Combo Fire/Supervisory
Combo w/AutoResettable Superv 2
2 AutoResettable means that a device with this type code, when activated, will
automatically reset when the corresponding condition is cleared.
Fire/Supervisory, nonlatching
2-Wire Smoke Fire Alarm
2-Wire Heat Fire Alarm
N/A
Linear Heat Fire Alarm
N/A
N/A
Fire Fire Alarm
Low Pressure Supervisory, latching
Low Pressure AutoResettable2 Supervisory, nonlatching
High Pressure Supervisory
High Pressure AutoResettable2 Supervisory, nonlatching
Disable Release 3
3 Disable Release allows the installer to disable the releasing solenoids during
system testing. Disable Release will only work when the system is not in alarm.
Supervisory, nonlatching (disables Release Circuits)
Supervisory Supervisory, latching
Supervisory AutoResettable2 Supervisory, nonlatching
N/A
2nd-Shot Water Switch 4
4 The 2nd-Shot Water Switch provides the option of performing another immediate
water release manually. Refer to “2nd-Shot Water Switch” on page 91.
Fire Alarm, nonlatching
Table 3.1 Zone Types