1 facp configuration, 2 input zones, Facp configuration 4.15.2: input zones – System Sensor PDRP-2001 User Manual

Page 94

Advertising
background image

94

PDRP-2001 Series Manual — P/N 53043:E1 2/28/2011

Operating Instructions

Read Status

The following screens will be displayed:

4.15.1 FACP Configuration

Pressing 1 while viewing Read Status Screen #1 will display the type of configuration programmed
into the FACP (refer to “FACP CONFIG (Application Templates)” on page 51). As an example, if
Template 7 was programmed as the FACP configuration, the following screen will be displayed:

4.15.2 Input Zones

Pressing 2 while viewing Read Status Screen #1 will cause the following screens to be displayed:

Pressing the down arrow key will allow the selection of Zones 4-6.

READ STATUS
1=FACP CONFIG
2=INPUT ZONES
3=OUTPUT CIRCUITS

READ STATUS
1=CROSS INPUT ZONES
2=ON-BOARD RELAYS
3=SYSTEM SETTINGS

Read Status Screen #1

Read Status Screen #3

READ STATUS
1=TIMERS
2=DAYLIGHT SAVINGS
3=HISTORY

Read Status Screen #2

READ STATUS
1=PRINT
2=ANN-BUS

Read Status Screen #4

READ FACP CONFIG

TEMPLATE 7

SINGLE HAZARD

3 ZONE

READ INPUT ZONES
1=ZONE 1
2=ZONE 2
3=ZONE 3

Advertising