System Sensor PDRP-2001 - Manual (Page 59)

PDRP-2001 Series Manual — P/N 53043:E1 2/28/2011 59
Master Programming Level Programming
Pressing the down arrow key while viewing the Edit Output Type Screen will display additional
screens with the types shown below:
 Release Circuit 1
 Release Circuit 2
 Alarm NAC
 Waterflow NAC
 Release Stage NAC
 Horn NAC
 Strobe NAC
 Supv Bell NAC
 Trouble Bell NAC
Press the number key corresponding to the desired Output Type to program the selected Output.
 Release Circuit 1 or Release Circuit 2
If Release Circuit 1 or Release Circuit 2 is selected as the Output Type, the following subscreen
will be displayed:
This screen allows the programmer to select whether or not to supervise the Releasing Circuit
Output for shorts.
• UNSUPV SHORTS - this option should normally be selected when a releasing solenoid is
connected to the output so the solenoid coil is not supervised for shorts
• SUPV SHORTS - this option, which supervises for shorts, should only be selected when the
REL-4.7K option is installed in series with the solenoid coil
 Release Stage NAC
If Release Stage NAC is selected as the Output Type, the following subscreen will be displayed:
EDIT RELEASE CIR #
1=UNSUPV SHORTS
2=SUPV SHORTS
NOTE: Release circuits may be directly activated by a single input zone or may be activated
using cross-zoned inputs. Refer to “Circuit Mapping and Cross-Zoning” on page 104 for a
description of cross-zoning and input to output circuit mapping.
RELEASE STAGES
1=RELEASE 1 ONLY
2=RELEASE 2 ONLY