Dlp-2 logging in to the system, Dlp-2, Logging in to the system – ADTRAN 600R User Manual
Page 189: To dlp-2, logging in, To the system for detailed instructions.)
61200624L1-1B
© 2004 ADTRAN, Inc.
187
DLP-2 Logging in to the System
Introduction
Once connected to the Total Access 6XX, you must login to the system to gain access to the management
and provisioning functions. This DLP assumes you are connected to the Total Access 6XX and provides
specific steps for logging into the system.
Prerequisite Procedures
Complete DLP-1, Connecting a VT100 Terminal or PC to the CRAFT Port.
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
Electronic equipment can be damaged by static electrical discharge. Before handling
modules, put on an antistatic discharge wrist strap to prevent damage to electronic
components. Place equipment in antistatic packing material when transporting or storing.
When working on equipment, always place it on an approved antistatic mat that is
electrically grounded.
After the IP parameters have been provisioned (see DLP-3, Setting IP Parameters), you
can also log in via Telnet.