Additel 221A Multifunction Temperature Calibrator User Manual - Manual (Page 42)

________________________________________________________________________________________________________________
35
Figure 8.12 Stepping Results
Stepping supports three modes: an engineering unit, scale and step points.
Note:
In the engineering unit and stepping mode, the transfer functions default setting is always linear.
Only for auto step, the run mode and step time are valid. The range of the Step time is 1 to 3600 seconds.
To use manual stepping, proceed as follows:
1. If necessary, press the navigation keysUp/Downuntil source is active.
2. PressStep to show the step setup interface, and configure these parameters as follows:
 Start Value(in units)