GW Instek PSW-Series Programming & Command manual - Manual (Page 21)

GETTING STARTED
21
Configuration Settings
Configuration of the PSW power supplies is divided into five
different configuration settings: Normal Function, USB/GPIB, LAN,
Power ON Configuration, Calibration Settings and System Settings.
Power ON Configuration differs from the other settings in that the
settings used with Power ON Configuration settings can only be set
during power up. The other configuration settings can be changed
when the unit is already on. This prevents some important
configuration parameters from being changed inadvertently. Power
On Configuration settings are numbered F-90 to F-95 and the other
configuration settings are numbered F-00 to F-61 and F-88 to F-89.
Setting Normal Function Settings
The normal function settings (F-01~F-61, F-88~F-
89) can be easily configured with the Function key.
 Ensure the load is not connected.
 Ensure the output is off.
Note
Function setting F-89 (Show Version) can only be
viewed, not edited.
Configuration settings F-90~F-95 cannot be edited
in the Normal Function Settings. Use the Power
On Configuration Settings. See page 22 for details.
Steps 1. Press the Function key. The
function key will light up.
Function
2. The display will show F-01
on the top and the
configuration setting for
F-01 on the bottom.