GW Instek PSW-Series Programming & Command manual - Manual (Page 80)

PSW Series Programming Manual
80
OFF Turns the buzzer off.
1 <NR1> Turns the buzzer on.
ON Turns the buzzer on.
Return parameter <Boolean> Returns the buzzer status.
SYSTem:CONFigure:BLEeder[:STATe]
Set
Query
Description Sets or queries the status of the bleeder resistor.
Syntax
Query Syntax SYSTem:CONFigure:BLEeder[:STATe] {OFF|ON|0|1}
SYSTem:CONFigure:BLEeder[:STATe]?
Parameter 0 <NR1> Turns the bleeder resistor off.
OFF Turns the bleeder resistor off.
1 <NR1> Turns the bleeder resistor on.
ON Turns the bleeder resistor on.
Return parameter <Boolean> Returns bleeder resistor status.
SYSTem:CONFigure:BTRip[:IMMediate]
Set
Description Trips the power switch trip (circuit breaker) to
turn the unit off (shut down the power).
Syntax SYSTem:CONFigure:BTRip[:IMMediate]
SYSTem:CONFigure:BTRip:PROTection
Set
Query
Description Enables/Disables the power switch trip (circuit
breaker) when the OVP or OCP protection settings
are tripped. This setting only applies after power
has been reset.
Syntax SYSTem:CONFigure:BTRip:PROTection {OFF|ON|0|1}
Query Syntax SYSTem:CONFigure:BTRip:PROTection?
Parameter 0 <NR1> Disables the power switch trip for
OVP or OCP.
OFF Disables the power switch trip for OVP or
OCP.
1 <NR1> Enables the power switch trip for
OVP or OCP.