GW Instek PSW-Series Programming & Command manual - Manual (Page 87)

REMOTE CONTROL
87
SYSTem:COMMunicate:LAN:WEB:PASSword
Set
Query
Description Sets or queries the web password. This setting is
applied only after the unit is reset.
Syntax
Query Syntax SYSTem:COMMunicate:LAN:WEB:PASSword <NR1>
SYSTem:COMMunicate:LAN:WEB:PASSword?
Parameter/Return <NR1> 0 ~ 9999
Example
SYST:COMM:LAN:WEB:PASS 1234
Set the web password as 1234.
SYSTem:COMMunicate:USB:FRONt:STATe
Query
Description Queries the front panel USB-A port state.
Query Syntax SYSTem:COMMunicate:USB:FRONt:STATe?
Return parameter 0 <NR1>Absent
1 <NR1>Mass Storage
SYSTem:COMMunicate:USB:REAR:STATe
Query
Description Queries the rear panel USB-B port state.
Query Syntax SYSTem:COMMunicate:USB:REAR:STATe?
Return parameter 0 <NR1>Absent
1 <NR1>USB-CDC
2 <NR1>GPIB-USB (GUG-001)
SYSTem:COMMunicate:USB:REAR:MODE
Set
Query
Description Sets or queries the rear panel USB-B port mode.
This command is the equivalent to the F-22
configuration setting.
Syntax
Query Syntax SYSTem:COMMunicate:USB:REAR:MODE {0|1|2|3}
SYSTem:COMMunicate:USB:REAR:MODE?