GW Instek PSW-Series Programming & Command manual - Manual (Page 92)

PSW Series Programming Manual
92
Description Performs a device reset. Configures the unit to a
known configuration (default settings). This
known configuration is independent of the usage
history.
Syntax *RST
*SRE
Set
Query
Description Sets or queries the Service Request Enable register.
The Service Request Enable register determines
which registers of the Status Byte register are able
to generate service requests.
Syntax
Query Syntax *SRE <NR1>
*SRE?
Parameter <NR1> 0~255
Return parameter <NR1> Returns the bit sum of the Service Request
Enable register.
*STB
Query
Description Queries the bit sum of the Status Byte register with
MSS (Master summary Status).
Query Syntax *STB?
Return parameter <NR1> Returns the bit sum of the Status Byte register
with the MSS bit (bit 6).
*TRG
Set
Description The *TRG command is able to generate a “get”
(Group Execute Trigger). If the PSW cannot accept
a trigger at the time of the command, an error
message is generated (-211, “Trigger ignored”).
Syntax *TRG
*TST
Query