GW Instek PSW-Series Programming & Command manual - Manual (Page 67)

REMOTE CONTROL
67
Parameter <NRf> 0~32767
Return parameter <NR1> 0~32767
STATus:PRESet
Set
Description This command resets the ENABle register, the
PTRansistion filter and NTRansistion filter on the
Operation Status and Questionable Status
Registers. The registers/filters will be reset to a
default value.
Default Register/Filter Values
Setting
QUEStionable Status Enable 0x0000
QUEStionable Status Positive Transition 0x7FFF
QUEStionable Status Negative Transition 0x0000
Operation Status Enable
0x0000
Operation Status Positive Transition 0x7FFF
Operation Status Negative Transition 0x0000
Summary: The Questionable Status Enable
registers and the Operation Status Enable registers
are both reset to 0.
The Questionable Status and Operation Status
Positive Transition filters are all set high (0x7FFF)
and the Negative Transition filters are all set low
(0x0000). I.e., only positive transitions will be
recognized for the Questionable Status and
Operation Status registers.
Syntax STATus:PRESet