GW Instek PSW-Series Programming & Command manual - Manual (Page 22)

PSW Series Programming Manual
22
3. Rotate the voltage knob to change
the F setting.
Voltage
Range F-00~ F-61, F-88~F-89
4. Use the current knob to set the
parameter for the chosen F setting.
Current
5. Press the Voltage knob to save the
configuration setting. ConF will be
displayed when successful. Voltage
Exit
Press the Function key again to exit
the configuration settings. The
function key light will turn off.
Function
Setting Power On Configuration Settings
Background
The Power On configuration settings can only be
changed during power up to prevent the
configuration settings being inadvertently
changed.
 Ensure the load is not connected.
 Ensure the power supply is off.