GW Instek PSW-Series Programming & Command manual - Manual (Page 73)

REMOTE CONTROL
73
[SOURce:]VOLTage[:LEVel]:TRIGgered
[:AMPLitude]
Set
Query
Description Sets or queries the voltage level in volts when a
software trigger has been generated.
Syntax [SOURce:]VOLTage[:LEVel]:TRIGgered[:AMPLitude]
{<NRf>|MIN|MAX}
Query Syntax [SOURce:]VOLTage[:LEVel]:TRIGgered[:AMPLitude]?
[MIN|MAX]
Parameter/Return <NRf> 0%~105% of the rated voltage output in volts.
MIN Minimum current level.
MAX Maximum current level.
Example SOUR:VOLT:LEV:TRIG:AMPL 10
Sets the voltage level to 10 volts when a software
trigger is generated.
[SOURce:]VOLTage:PROTection[:LEVel]
Set
Query
Description Sets or queries the overvoltage protection level.
Syntax [SOURce:]VOLTage:PROTection[:LEVel]
{<NRf>|MIN|MAX}
Query Syntax [SOURce:]VOLTage:PROTection[:LEVel]? [MIN|MAX]
Parameter/Return <NRf> OVP range in volts.
MIN Minimum OVP level
MAX Maximum OVP level
Example SOUR:VOLT:PROT:LEV MAX
Sets the OVP level to its maximum.
[SOURce:]VOLTage:SLEW:RISing
Set
Query
Description Sets or queries the rising voltage slew rate. This is
only applicable for CV slew rate priority mode.