HP 3PAR Operating System Software - Manual (Page 154)

•
-snp_cpg <cpg_name> <target_name>:<cpg_name>... —The local snapshot CPG
and target snapshot CPG that will be used for volumes that are autocreated
•
<group_name> —Name of the volume group
To unset all user and snapshot CPGs that are associated with the volume group, issue the
setrcopygroup
command with the cpg subcommand and -usr_cpg_unset and
-snp_cpg_unset options, as follows:
# setrcopygroup cpg -usr_cpg_unset -snp_cpg_unset <group_name>
Automatically Creating Target Volumes on the Secondary System
To create a volume automatically on the secondary storage system, the primary volume must first
be created on the source system. On the source system, issue the admitrcopyvv command with
the -createvv option, as follows:
# admitrcopyvv [options] -createvv <VV_name> [:<snapname>] <group_name>
<target_name>:<sec_VV_name>...
where:
•
-nosync (option)—Specifies that the volume should skip the initial sync. This is for the
admission of volumes that have been pre-synced with the target volume. This specifier cannot
be used when starting snapshots (<VV_name:<snapname>) are specified.
•
-createvv —Specifies that the secondary volumes should be created automatically on the
target using the CPG associated with the remote-copy group on that target.
•
<VV_name> [:<snapname>] <group_name> —An optional read-only snapshot
<snapname> can be specified along with the virtual volume name <VV_name>. This snapshot
is a starting snapshot. When the group is started, a full synchronization is not performed.
Instead, for synchronous groups, the volume will synchronize deltas between <snapname>
and the base volume. For periodic groups, the volume will synchronize deltas between
<snapname>
and a snapshot of the base.
CAUTION: The <snapname> should not be specified with the -createvv option. The new
volume would contain only changes, not a fully synchronized copy of the primary volume.
•
<target_name>:<sec_VV_name> —The target name associated with the volume group
and secondary volume name
Issue the showrcopy -d command to view the associated local and target CPG information and
all target volumes that are automatically created.
NOTE: The target volume is created using the same volume WWN as the primary volume.
Automatically Deleting Target Volumes on the Secondary System
NOTE: When using the -removevv option, primary volumes are not deleted; only secondary
side volumes are deleted.
To automatically delete the volumes on the secondary storage system, issue the dismissrcopyvv
command with the -removevv option:
# dismissrcopyvv -removevv <VV_name> <group_name>
154 Managing VASA-connected Remote-Copy Groups and Volumes