Setting the gateway – HP 3PAR Operating System Software User Manual
Page 31
4.
Repeat
through
for each Ethernet port on each HP 3PAR StoreServ Storage used
in the remote-copy configuration.
5.
Issue the following command on each system:
# showport -rcip
6.
Compare the IP addresses and netmask with your RCIP worksheet(s). For example:
N:S:P State ---HwAddr--- IPAddr Netmask Gateway MTU
Rate Duplex AutoNeg
0:3:1 ready 000423CBF68C 10.100.24.107 255.255.255.0 -- 1500
1Gbps Full Yes
1:3:1 ready 000423CBF693 10.101.24.107 255.255.255.0 -- 1500
1Gbps Full Yes
Solution
Problem
Repeat from
to reconfigure the addresses.
The output does not match the information on your
worksheet.
Setting the Gateway
Because the storage systems in the remote-copy configuration are on different subnets (the required
setup), you must set the gateways for each system. Perform the following steps to set the gateway:
1.
Issue the following command for an Ethernet port on one system:
# controlport rcip gw <gateway_IP> <N:S:P>
where:
•
<gateway_IP>
—Gateway IP address to assign to the local Ethernet port
•
<N:S:P>
—Location of a local Ethernet port
2.
Enter y to confirm that you want to make the gateway change.
3.
Repeat
and
for each Ethernet port on each storage system used in the
remote-copy configuration.
4.
Issue the following command on each system:
# showport -rcip
5.
Verify that the Gateway column displays the correct gateway IP address:
N:S:P State ---HwAddr--- IPAddr Netmask Gateway MTU
Rate Duplex AutoNeg
0:3:1 ready 000423CBF68C 10.100.24.107 255.255.255.0 10.100.24.1 1500
1Gbps Full Yes
1:3:1 ready 000423CBF693 10.101.24.107 255.255.255.0 10.101.24.1 1500
1Gbps Full Yes
Solution
Problem
Repeat from
to reconfigure the gateways.
The setup does not match the information on your
worksheet.
Setting Up Remote Copy over IP
31