HP 3PAR Operating System Software - Manual (Page 80)

2. To define a target on the backup system (System2), issue the following command:
•
For RCIP:
# creatercopytarget <target_name> IP <N:S:P>:<link_IP_addr>
<N:S:P>:<link_IP_addr>
where:
◦
<target_name> —Name of the target system (System1)
◦
IP —Defines link as an IP link
◦
<N:S:P> —Location on the current system (System2) that contains the IP connections
to the target system, expressed as node:slot:port
◦
<link_IP_addr> —Link IP address for the corresponding port on the target system
(for example, XXX.XX.1.10 or XXX.XX.1.11)
•
For RCFC:
# creatercopytarget <target_name> FC <node_WWN> <N:S:P:WWN> <N:S:P:WWN>
where:
◦
<target_name> —Name of the target system (System1).
◦
FC —Defines link as an FC link
◦
<node_WWN> —WWN of the node on the target system.
◦
<N:S:P:WWN> —Location on the current system (System2) of the FC adaptor port,
expressed as node:slot:port, and the WWN of the corresponding port on the target
system.
Checking the Links between Systems for Unidirectional Remote Copy
1. To check the links between the primary and backup systems, issue the showrcopy command:
# showrcopy
It might take several minutes for the links to come up between the two storage systems.
NOTE: See the HP 3PAR Command Line Reference for complete details on the showrcopy
command, including valid synchronization, link, and group states.
To access this document, go to the HP 3PAR StoreServ Storage site and click the Support link
for your product:
www.hp.com/go/3par
2. Verify that:
•
The Target Information area shows a Status of ready.
•
The Link Information area shows a Status of Up for all the links.
80 Unidirectional Configuration