HP 3PAR Operating System Software - Manual (Page 238)

# showrcopy
Remote Copy System Information
Status: Started, Normal
Target Information
Name ID Type Status Options Policy
SystemA 46 FC failed 2FF70002AC000060 mirror_config
SystemC 47 IP ready mirror_config
Link Information
Target Node Address Status Options
SystemA 0:2:1 20210002AC000060 Down
SystemA 1:2:1 21210002AC000060 Down
SystemC 0:4:1 10.100.33.63 Up
SystemC 1:4:1 10.101.33.63 Up
receive 0:2:1 20210002AC000060 Up
receive 1:2:1 21210002AC000060 Up
receive 0:4:1 receive Up
receive 1:4:1 receive Up
Group Information
Name Target Status Role Mode Options
multi.1.r96 SystemA Backup Secondary Sync
LocalVV ID RemoteVV ID SyncStatus LastSyncTime
testvv.0 200 testvv.0 100 Synced NA
testvv.1 201 testvv.1 101 Synced NA
testvv.2 202 testvv.2 102 Synced NA
testvv.3 203 testvv.3 103 Synced NA
Name Target Status Role Mode Options
multi.1.r96 SystemC Started Secondary Periodic Period 5m, over_per_alert
LocalVV ID RemoteVV ID SyncStatus LastSyncTime
testvv.0 200 testvv.0 300 Synced 2009-06-29 14:44:09 PDT
testvv.1 201 testvv.1 301 Synced 2009-06-29 14:44:10 PDT
testvv.2 202 testvv.2 302 Synced 2009-06-29 14:44:09 PDT
testvv.3 203 testvv.3 303 Synced 2009-06-29 14:44:10 PDT
Recovery
1. Recover the failed system.
NOTE: If remote copy is configured with the auto_recover policy and you manually
stopped the volume groups on the primary system, HP 3PAR Remote Copy automatically
attempts to restart these volume groups.
2. When the primary system is ready to resume normal operation, reverse the natural direction
of data flow and resynchronize the systems.
On the failover system (SystemC), issue the following command:
# setrcopygroup recover -f -t <target_name>
where <target_name> represents the name of the target system with which to synchronize
(SystemA).
238 Disaster Recovery for SLD Configurations