HP 3PAR Operating System Software - Manual (Page 186)

2. Verify the reversal of volume group roles.
a.
Issue the showrcopy command on the failover system (System1).
b. In the Group Information area, check that the Role column for the reversed volume
group displays Primary-Rev (primary as a result of reversal).
For example, the showrcopy output for System1 shows that the role of
periodic_group_1.r96
is now Primary-Rev:
# showrcopy
Remote Copy System Information
Status: Started, Normal
Target Information
Name ID Type Status Options Policy
System2 7 IP failed mirror_config
System3 8 IP ready mirror_config
Link Information
Target Node Address Status Options
System2 0 10.100.33.96 Down
System2 1 10.101.33.96 Down
System3 0 10.100.33.11 Up
System3 1 10.101.33.11 Up
receive 0 10.100.33.96 Up
receive 1 10.101.33.96 Up
Group Information
Name Target Status Role Mode Options
periodic_group_1.r96 System2 Stopped Primary-Rev Periodic over_per_alert
LocalVV ID RemoteVV ID SyncStatus LastSyncTime
remotevv.0 21 localvv.0 413 Stopped Thu Dec 14 18:23:52 PST 2006
remotevv.1 22 localvv.1 414 Stopped Thu Dec 14 18:23:52 PST 2006
Name Target Status Role Mode Options
periodic_group_2.r11 System3 Started Secondary Periodic over_per_alert
LocalVV ID RemoteVV ID SyncStatus LastSyncTime
remotevv.2 23 localvv.0 385 Synced Thu Dec 14 18:23:45 PST 2006
remotevv.3 24 localvv.1 386 Synced Thu Dec 14 18:23:44 PST 2006
3. (Optional) To back up data in the reversed volume groups, export the reversed virtual volumes
(remotevv.0 and remotevv.1) as read/write snapshots.
Recovery for N-to-1 Remote-Copy Configurations
1. Recover the failed system.
186 Disaster Recovery for M-to-N Configurations