HP 3PAR Operating System Software - Manual (Page 203)

Figure 65 SLD Remote-Copy Configuration
Example asynchronous
periodic backup system Example synchronous
backup system Example primary system
SystemC SystemB SystemA System name
63 195 96 System ID
•
Four VVs, testvv.0 –
testvv.3
, belong to
primary volume group
multi.1
Virtual volumes and volume
groups:
Data flow:
SystemA —> SystemB
•
Four corresponding VVs:
testvv.0 – testvv.3
•
Four corresponding VVs:
testvv.0 – testvv.3
• •
One secondary volume
group: multi.1.r96 One secondary volume
group: multi.1.r96
SystemA —> SystemC
periodic —> SystemA synchronous —> SystemA sync —> SystemB mode
periodic —> SystemC
Failover system Failed/recovered system Disaster recovery role
System Information during Normal Operation for SLD Configurations
Primary System (SystemA) Information for SLD Configurations
When all systems are up, the showrcopy command output on the primary system (SystemA) looks
like the following output for SLD configuration:
# showrcopy
Remote Copy System Information
Status: Started, Normal
Target Information
Name ID Type Status Options Policy
SystemB 58 FC ready 2FF70002AC0000C3 mirror_config
SystemC 59 IP ready mirror_config
Link Information
Target Node Address Status Options
SystemB 0:2:1 20210002AC0000C3 Up
System Information during Normal Operation for SLD Configurations 203