HP 3PAR Operating System Software - Manual (Page 210)

3. Verify the reversal of volume group roles:
a.
Issue the showrcopy command on the failover system (SystemB).
b. In the Group Information area, check that the Role column for the reversed volume
group displays Primary-Rev (primary as a result of reversal).
The following example of the showrcopy command output for SystemB shows that the role
of multi.1.r96 is now Primary-Rev in relation to both SystemA and SystemC:
# showrcopy
Remote Copy System Information
Status: Started, Normal
Target Information
Name ID Type Status Options Policy
SystemA 46 FC failed 2FF70002AC000060 mirror_config
SystemC 47 IP ready mirror_config
Link Information
Target Node Address Status Options
SystemA 0:2:1 20210002AC000060 Down
SystemA 1:2:1 21210002AC000060 Down
SystemC 0:4:1 10.100.33.63 Up
SystemC 1:4:1 10.101.33.63 Up
receive 0:2:1 20210002AC000060 Up
receive 1:2:1 21210002AC000060 Up
receive 0:4:1 receive Up
receive 1:4:1 receive Up
Group Information
Name Target Status Role Mode Options
multi.1.r96 SystemA Stopped Primary-Rev Sync
LocalVV ID RemoteVV ID SyncStatus LastSyncTime
testvv.0 200 testvv.0 100 Stopped 2009-06-29 12:12:16 PDT
testvv.1 201 testvv.1 101 Stopped 2009-06-29 12:12:16 PDT
testvv.2 202 testvv.2 102 Stopped 2009-06-29 12:12:16 PDT
testvv.3 203 testvv.3 103 Stopped 2009-06-29 12:12:16 PDT
Name Target Status Role Mode Options
multi.1.r96 SystemC Started Primary-Rev Periodic Last-Sync 2009-06-29 12:16:39 PDT ,
Period 5m, over_per_alert
LocalVV ID RemoteVV ID SyncStatus LastSyncTime
testvv.0 200 testvv.0 300 Synced 2009-06-29 12:16:39 PDT
testvv.1 201 testvv.1 301 Synced 2009-06-29 12:16:39 PDT
testvv.2 202 testvv.2 302 Synced 2009-06-29 12:16:39 PDT
testvv.3 203 testvv.3 303 Synced 2009-06-29 12:16:39 PDT
210 Disaster Recovery for SLD Configurations